Search results for "Area density"
showing 5 items of 5 documents
Research Regarding the Influence of Raw Material and Woven Fabric Geometry on the Air Permeability of Mattress
2017
Abstract Properties of woven fabrics are influenced by many factors: the nature of raw materials, woven fabric geometry and density, technological parameters of the weaving operation and finishing. The main purpose of this research paper is to increase the performance of woven process during mattress manufacturing by choosing the right woven fabric geometry and raw material. The variation in air permeability depends on the area density, linear density, loop length and thickness of yarns. To obtain woven fabric samples were used several types of classic yarns, also ecological yarns like organic cotton and bamboo viscose. On the other side, tests results show the fabric resistance regarding a…
Formation and emission properties of single InGaAs/GaAs quantum dots and pairs grown by droplet epitaxy
2010
Trabajo presentado a la 30th International Conference on the Physics of Semiconductors, celebrada en Seul (Korea) del 25 al 30 de Julio de 2010.
Fine plastic foil as backing for sputtered nickel targets
2013
Targets of 58Ni and 60Ni with areal density between 71 and 105 μg/cm2 backed with polyimide foil of 35–40 μg/cm2 were prepared by sputtering with Ar ions produced by a home made sputtering device at the Target Laboratory, University of Jyväskylä. The efficiency of the procedure was about 20 %.
Detection of planar defects caused by ion irradiation in Si using molecular dynamics
2007
We have analyzed the evolution of defects caused by self-irradiation of crystalline silicon. A classical molecular dynamics simulation was followed by defect analysis using the Pixel Mapping (PM) method. The PM identified {311} planar defects and long-chain structures of the so-called interstitial chains following low energy (1 keV) ion impact. The areal density obtained from simulation of self-interstitial atoms was about two thirds of that of experiments reported in the literature [Jpn. J. Appl. Phys. 30 (1991) L639], while the atomic configuration on respective planes agreed exactly.
Surface area, density and porosity measurements using the magnetic suspension balance
1989
The advantage of gravimetry in the determination of surface area is discussed in comparison with the volumetric method. The magnetic suspension balance is described and new developments are presented. As an example of the application of gravimetric measurements the determination of apparent density and specific surface area before and after oxidation of a Poco graphite are described.